Note: ARCG Instructions are below.
The Deflector Brake was specifically designed to fit on standard MIL-SPEC style AR brass deflectors as shown. It will work with other styles and with many calibers but, results are not guaranteed. Although the Deflector Brake can take a lot of abuse it is recommended to swap it out after approx. 1000 rounds to maintain the desired effects. Please read all the directions to achieve the best results. Results will vary as no 2 rifles or shooting conditions are the same.
Deflector Brake Instructions
IMPORTANT: FOLLOWING DIRECTIONS FOR THIS ACCESSORY IS ESSENTIAL
THE ADHESIVE MUST BE ACTIVATED TO FUNCTION PROPERLY
Please note that we have not found a coating that our product will not stick to when applied properly. Some coatings hold oil in the microscopic dimples. We ask that you spend a few minutes making sure the brass deflector is extra clean and free from lubrication and completely dry. This will ensure you get the longevity the Deflector Brake was designed to deliver. Thanks
Instructions: Ensure the area is clean and dry, remove the brown adhesive backing, place, press on part for 10 seconds, SCRATCH OFF PROTECTIVE TOP COATING/FILM.